Click the “Yes” button on the “Update Driver Warning” window. 16385 from the list and click the “Next” button.ġ3. Select “XBOX 360 Controller For Windows Version. Scroll down to and double click “Microsoft Common Controller For Windows Class”.ġ2. Click “Let me pick from a list of device drivers on my computer” from the next window.ġ1. Click “Browse my computer for driver software” from the pop‐up window.ġ0. Select “Update Driver Software…” from the dropdown menu.ĩ. Find the controller in the list of devices as “Afterflow Gamepad for Xbox 360” and right click it.Ĩ. Click “Device Manager” from the list on the list to the left side of the “Computer Management” window.ħ. Select “Manage” from the drop down menu.Ħ. Click the “Start” button and right click on “Computer”. Click the link on the following page and run the driver installer.ĥ. Select “Controller” for product, “Xbox 360 Controller for Windows”, the operating system you are running and the appropriate language. If the below message appears in the lower left of your screen, the controller was not properly installed.ģ. If the controller does not automatically install, go to step 2. Plug in the Afterglow Controller to a USB Port. No this controller is produced exclusively for PS3 and PC.Afterglow Controller for Xbox 360 Windows 7 Installation Instructions Plug in the charge cable and check to see that the 4 LED’s on top of the controller are flashingĬan I use this controller on my PS4 or PS5? Make sure that your controller has a charge.Press and hold the Home button on the controller for approximately 3 seconds.There is also a 3 rd setting that activates the LED’s when the controller’s motors vibrate. There is a button or switch on the back of the controller that turns the LED’s on and off. My controller works, but why don’t the LED’s turn on when I connect my controller? Turn off the controller, and turn it back on without pressing any buttons at all. If you turn on the controller while pressing a button, or the analog stick in any direction, it could result in the button/direction being automatically registered.Press the analog stick down to verify that the stick is not popped out of position. ![]() My controller is reacting as if I am pressing a button/analog stick, but I am not pressing anything.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |